Can i hook up an amp to my stock radio
Adding a subwoofer and amplifier to your existing stereo is a great way to improve the bottom-end output of your system and is one of the most common upgrades performed on a car's audio gear. Connecting the Subwoofer to the Amplifier With the speaker wires, connect the subwoofer system wiring to the amplifier. Check the manuals included with your line-out converter, stereo and amplifier for complete installation instructions for your system. Connect the red power wire and ground wire you prepped earlier to the proper inputs on your amp. Make sure to connect positive to positive and negative to negative.
This converter can then be connected directly to your amplifier's line level inputs. However, do not connect the wire to the amplifier or battery yet. Adding an amp will make your audio system sound louder and clearer by allowing you to send more power to your factory speakers or sub-woofers. Now that your amp is tapped into your car's factory audio system, run speaker wires from the amp's speaker outputs to the speaker s or sub-woofer s you want the amp to power. Disconnect your car battery's negative terminal for safety purposes.
Run the red power wire from your amp installation kit from the positive terminal on your battery through your car's cabin to the location of the amp. Reconnect your car battery, and test your new audio system. Subwoofers can be large speakers that are usually housed in speaker enclosures installed in the trunk of the car. This tutorial will focus on how to add an amp by using speaker-level inputs to tap into your car's existing wiring. You can purchase a separate amplifier and speaker or you can purchase a powered subwoofer with a built-in amplifier.
Carefully splice into the positive and negative wire on both the right and left rear speakers using a wire stripper. Now attach a line of speaker wire to each splice and secure with electrical tape. Most amplifiers will have outputs for at least two speakers. Once you splice it, solder this wire to the remote wire of your stock stereo. Get the remote wire in your wiring kit.
You can use this to provide a more solid connection between the subwoofer, amplifier and the battery. Connecting the Power Wire to the Battery Connect the power wire to the battery of your car. If you don't already have one, purchase a car amplifier with speaker-level inputs and also purchase an amp installation kit.
Start from the battery and pass on to the amplifier. Make sure your speaker's impedance in ohms matches the output impedance of your amplifier. Connecting the Speaker Wires to the Subwoofer You can now connect the speaker wires to the subwoofer. You need to pass the wire through the firewall. If you installed a powered sub, you will not need to connect the amplifier and speaker, as they are already connected.
If the sound is scratchy, check that your connections are secure. The best location for the amp is usually the trunk. You could add additional subs to your system using these outputs. Mounting brackets and speaker enclosures can be purchased at any local car audio retailer.
After this is done, run the remote wire through the dashboard and the door jam. Run this wire back to your amp and hook it into the speaker-level inputs.
- Dating blues deluxe amp
- Comune nel medioevo yahoo dating
- Country connections dating agency
- Dating a woman with stretch marks
- Dating agency cyrano mvp
- Dating a normal guy sitcom
- Dating sites in shanghai
- Afro latino dating services
- Dating someone with a different culture
- Dragon ball z capitulo 193 194 latino dating
- Aakash tablet dealers in bangalore dating
- Dating coach for women new york
- Ang pagdating ng mga
- Best dating guide book